mike friedrichs
05-10-01, 12:53 PM
I've been looking for a definition of the function of pins 3 and 4(RTI) on the mfg web page. I can't find anything on the data sheets that discuss the RTI pins or recommended adjustment. I'm using this pcb in a vibration environment and would like to remove RV1, as shown on the SPCL schematic, from the pcb and replace with a fixed resistor or no resistor at all.
whats problems would i incur if this is done. If i observe an input offset of a few micro-volts that not a problem.
thanks,
Mike Friedrichs
whats problems would i incur if this is done. If i observe an input offset of a few micro-volts that not a problem.
thanks,
Mike Friedrichs