ServoPod Programing blunder

[Drewfus]

I was programming my servopod and had just got to the stage of setting it to run at startup. I some how stuff it up and now i seem to not be able to do anything. Is there some kind of factory reset and if there is, how??

[nmitech]

1. Jumper or Short out pin 2(GND) & 4(PE4) of J3 .
2. Press reset button to bypass the autostart.
3. When you get the IsoMax prompt, enter SCRUB to erase the application program.

Besure to remove the jumper ( PE4 & GND) for your new application program to run on startup.

[Drewfus]

Thanks :) now I can get back to automating my robot