clement sudhakar
03-14-02, 01:22 AM
I have a few doubts which i am unable to solve about maxterm...
1. Does nmix monitor V 1.0 reinitialise all registers in the process of reset operation.
2. I want to execute a assembly code. Is it possible to provide a breakpoint at the end of the code so that the execution happens without a reset ( the idea is that i would like to see the register contents iand internal data memoryy contents intact after execution)
3. If i perform a jump to 0000H location at the end of my code, will it reinitialise the controller
Thank you and regards
clement
1. Does nmix monitor V 1.0 reinitialise all registers in the process of reset operation.
2. I want to execute a assembly code. Is it possible to provide a breakpoint at the end of the code so that the execution happens without a reset ( the idea is that i would like to see the register contents iand internal data memoryy contents intact after execution)
3. If i perform a jump to 0000H location at the end of my code, will it reinitialise the controller
Thank you and regards
clement