problem loading code onto PLUGAPOD

[ai4presidente]

Hi,

So I was running some code yesterday (no connections to any of the pins). And my code froze. So I reset the plugapod, and tried to flash on a version of code that I knew works properly. However, that code refused to load properly. What would happen was, as soon as the compiler reached a command for a variable such as
3337 CONSTANT MINPOS EEWORD ( ~.59 mS
The terminal window would just stall at that command, and would not continue on to the rest of the code. I tried to flash the plugapod by connecting a jumper from PE4 to ground, but this did not fix the problem. I did replace the plugapod with a different one, and the problem went away.

Here is what I know,
when I press the reset button,
IsoMax V0.82 appears on the screen
In addition, I am still able to control the leds using the terminal window.

I am not quite sure what has happened to the plugapod, I am guessing something has gone wrong with the software, because I am sure that the chip was not exposed to voltages of any kind.

Thanks for your help

[nmitech]

If the Pod is still responding to the console, just enter SCRUB and reload the new program. No need to jumper on PE4 & GND.