NMIX/T-0020 and THRsim11

[mod]

Hi

Well I'm a total noob in microcontrolers, so excuse me for the dumb questions.

I just purchased the nmix board from one of your reseller in france, and I can't seem to be able to use it

I turned off maxforth so now it's running buffalo. When I connect the target board in thrsim11 everything seems to go fine, I download my program to it. At this point everything is OK

{EDITED: Sorry no Link with AD images allow }

the problem appears when I try to run the program by clicking on target step. I always get this message : cannot read from serial port and just after cannot write to serial port. I'm a noob so I don't even know if I'm missing something or if the board is not working properly, any help would be appreciated thanks

[nmitech]

I turned off maxforth so now it's running buffalo. When I connect the target board in thrsim11 everything seems to go fine, I download my program to it. At this point everything is OK .

the problem appears when I try to run the program by clicking on target step. I always get this message : cannot read from serial port and just after cannot write to serial port. I'm a noob so I don't even know if I'm missing something or if the board is not working properly, any help would be appreciated thanks

Sorry, We are not familiar with the THRsim11 debug software. My advice is to contact the THRsim11 vendor, or GOOGLE on line and using the key word, THRsim11 to obtain more information.

[mod]

ok, I have found the answer

thrsim11 presents a little incompatibility with buffalo 3.4 and nmix0020

I switched to buffalo 2.3 now it's working smoothly.