ATN line on ServoPod

[gtiani]

Product: ServoPod, Isomax 0.82
I have a very small issue. I am trying to disable the reset capability feature through the serial port ATN line by grounding the ATN line on J1. But, it did not seem to work. I traced the etch and it looks like the ATN and RESET label on the schematic is reversed. I think ATN comes in on pin 6 of J1 and RESET on pin 5. My schematic shows the reverse (schematic BCM03). Could you please verify that?

Thank you,
Gary

[Dave]

Your tracing is correct, RESET is pin 5 on the outside of the board on J1 and ATN is pin 6 towards the MCU.

The schematic BCM03 shows the reversed incorrect connection, however the board BCM03 has the pinout you've found which matches the other Pods. We will correct the schematic as soon as possible.

The corrected schematic (http://www.newmicros.com/store/product_schematics_pdf/ServoPod.pdf) is available now.

(corrected wording)