XBOOT/or Software boot jump

[BJ Freeman]

I would like you to conside making XBOOT a jumper configuration. The other is to have a Address defined that would jump to a memory address(in flash memory) on boot.

there could be a word in ISOMAX that sets this memory location.

I am still comming up to speed on ISOMAX so it may already in there.

YES, I know, it creates a support night-mare. The simple solution is, that is someone uses this, they are on thier own.

[nmitech]

BJ Freeman,

I am not sure what you want to do with the XBOOT jumper? You meant to execute the application program on power up? If That is the case, IsoMax will have the word INSTALL to autostart your program in the soon to be released V0.3

[BJ Freeman]

So I would bring up a fresh IsoPod that I have additional program memory attached. I would use the INSTALL word, to give it a address of the Program memory.

When I reset the IsoPod it would go immediately to the program memory, or would it install the IsoMax then go to the installed memory.