Forth Startup

[gfs1989]

Hello! <p> I am not obtaining to install language FORTH in board NMIY-0031 just acquired. I followed the instructions to burn another GAL with archive GALU9.JED, burnt a EPROM with archive FORTH31.HEX, added plus a memory circuit RAM in U4 and changed jumper H3 for " program and data". Unhappyly when the board is energized, nothing it happens. When I place the original components (EPROM with monitor and the original GALU9) the board comes back to function. The board is without peripherals. I still do not possess a GAL/EPROM recorder. I requested to a firm that executed the job. When I communicated that the board had not functioned, I got the reply: we only made what he was requested, or either, to record the IS with the archives supplied for the customer. The<br>archives supplied in the diskette are correct? What I can make to identify what is missed? <p> <br>

[nmitech]

System requirements for NMIY-0031 boots up with Max-FORTH,<br>- U2, 8K-byte Eprom must program with FORTH31.HEX file provided in the diskette.<br>- U9, 16V8 GAL must program with the GALU9.JED file provided in the diskette.<br>- U3 needs a minimum of 8K-byte Sram.<br>- U4 needs a 32k-byte SRAM.<br>- Jumpers H2, H3, H4, H5 are jumpered from center pin toward to serial connection (away from memories devices). <br>- Jumper 'O' & 'P' must setting for proper memory devices (srams) you install on U3 and U4.<p>If you follow the procedures above and could not get the FORTH prompt, Please email to: nmiproduction@newmicros.com to obtain an RMA number and send the system back for diagnostic.<p><br>