isopod pin connections

[Joe Zink]

I've got an isopod V2 with the controller interface board. I would like to take readings from the PA and PB I/O lines for the purposes of using the device to read data and trigger relays. I would prefer not to solder to the board and the plug in areas live under the isopod board where space is tight. I'd like to be able to clip wires to these lines and read from the wires. What's the best method for that??
Thanks

[nmitech]

I would prefer not to solder to the board
... What's the best method for that??

How's about this,

Unplug the IsoPod from J4 connector of the controller board, and remove the 24 pin right angle header off J1 connector of the IsoPod.

Plug the J1 of the IsoPod on J3 of the controller interface board, vertically (90 degree angle)

Now you can insert the 24 pin right angle header with the short length pins on J4 and the longer pins pointing out off the board so you can clip or just insert the wires directly into J4 female connector just like insert the wires on the breadboard.