cannot save program to the flash of a new Servopod

[z_ruixiang]

I cannot save the program in the flash now. But I've used the same program for long time. It worked very well. I changed a new Servopod. When I write the program into the flash and reset it, the program was gone. Why? Thanks.

[nmitech]

Can you email me techsupport@newmicros.com your program? Thanks!

[RMDumse]

I have this problem with program saving sometimes when I make minor edits and leave an EEWORD off a little definition like a variable or constant, or a IN-EE off a transition. I see you say you are using the same program, but have you done any edits to it?

Then, also, which version are you using? Is the version of the software different between your previous boards and the new one?